FAC
ENEC :: The ENEC-Symbol is the European safety symbol for luminaires. The test regulations are determined by the European standard 60 598. The ENEC-Symbol is issued in combination with the identification number of a European test center (VDE = 10) This documents that the luminaires have been built and tested in "conformity with the standards" as per the Low-voltage Directive 2006/95/EC.
VDE :: Reiss standard luminaires are VDE-approved. They have the VDE-approval and are continuously tested in strictly stipulated quality controls. These controls are supervised by the VDE.
CE :: The CE-identification is performed by the manufacturer. The manufacturer, at the manufacturers own responsibility, hereby confirms conformity with the respective EC or EU directives. Conformity in accordance with the Low-voltage Directive and the EMV Directive (interference immunity, emitted interference) is the precondition for the CE-identification for our products.
D :: New EN-test mark 'D' replaces the national FF-symbol.
Protection class I :: Luminaires of protection class I: The luminaire is designed for connection to a rotective conductor.Protection class I is not identified by a symbol. The symbol indicating the protective earth is often used. Unless specified otherwise, all luminaires by REISS at least comply with protection class I.
IP 67 :: dust-tight (no ingression of dust) and protected from immersion (with details about pressure and time).
IP 65 :: dust-tight (no ingression of dust) and protected from jet water (from all directions).







Durchgangs-Verdrahtung halogenfrei / Through-wiring halogen-free*
TypArtikel Nr.
TypeItem no.
FA* - DV 36 | 28 | 54W 5 x 1.5 mm230 060 015
FA* - DV 36 | 28 | 54W 5 x 2.5 mm230 060 016
FA* - DV 58 | 35 | 49W 5 x 1.5 mm230 060 020
FA* - DV 58 | 35 | 49W 5 x 2.5 mm230 060 021
Aluminium Reflektor symmetrisch / Aluminium reflector symmetrical T16 (T5) + T26 (T8)
TypArtikel Nr.
TypeItem no.
FA* - REF 1/18/14/24W AL 36 070 200
FA* - REF 1/36/28/54W AL 36 070 201
FA* - REF 1/58/35/49/80W AL 36 070 202
FA* - REF 2/18/14/24W AL 04 784 752
FA* - REF 2/36/28/54W AL 04 784 753
FA* - REF 2/58/35/49/80W AL 04 784 754
Distanzteil (4 Stck.) | Distance piece (4 pcs.)03 613 866
Befestigungsschraube (2 Stck.) | Screw (2 pcs.) 04 782 291

Montage-Set / Mounting set*
TypArtikel Nr.
TypeItem no.
FA* - Multi-Set70 424 825

*Quick mounting set for wall and ceiling or chain and catenary suspension.



Edelstahlverschluss / Stainless steel clip
TypArtikel Nr.
TypeItem no.
FAC/FAD-VERS (Inox)04 784 306

Druckausgleichselement M12 / Pressure compensation unit M12
TypArtikel Nr.
TypeItem no.
KIT DAE M1204 926 631

Membranes allow for pressure compensation between the housings's inside and the ambient area, in order to avoid critical excessive and/or negative pressure caused by temperature fluctuations.