ENEC :: The ENEC-Symbol is the European safety symbol for luminaires. The test regulations are determined by the European standard 60 598. The ENEC-Symbol is issued in combination with the identification number of a European test center (VDE = 10) This documents that the luminaires have been built and tested in "conformity with the standards" as per the Low-voltage Directive 2006/95/EC.
VDE :: Reiss standard luminaires are VDE-approved. They have the VDE-approval and are continuously tested in strictly stipulated quality controls. These controls are supervised by the VDE.
CE :: The CE-identification is performed by the manufacturer. The manufacturer, at the manufacturers own responsibility, hereby confirms conformity with the respective EC or EU directives. Conformity in accordance with the Low-voltage Directive and the EMV Directive (interference immunity, emitted interference) is the precondition for the CE-identification for our products.
D :: New EN-test mark 'D' replaces the national FF-symbol.
Protection class I :: Luminaires of protection class I: The luminaire is designed for connection to a rotective conductor.Protection class I is not identified by a symbol. The symbol indicating the protective earth is often used. Unless specified otherwise, all luminaires by REISS at least comply with protection class I.
IP 67 :: dust-tight (no ingression of dust) and protected from immersion (with details about pressure and time).
IP 65 :: dust-tight (no ingression of dust) and protected from jet water (from all directions).
FA 1/36W PC
FA 2/36W PM
FA 1/36W PC | η 82%
— C0-C180
— C90-C270
FA 2/36W PM | η 70%
— C0-C180
— C90-C270

Technical description

Moisture-proof diffuser luminaire: Body made of hardly flammable, light grey polycarbonate (PC). Non-ageing polyurethane foam gasket (PU). Standard reflector made of galvanised sheet steel, coated with white polyester lacquer for optimum rust protection. No separate catches required thanks to integrated fastening mechanism. Diffuser made of polycarbonate (PC) with internal longitudinal prisms or polymethylmethacrylate (PMMA) with pearl structure. With automatic terminal. Completely halogen-free luminaire.

Suitable for ambient temperature:

  • -20°C to +35°C


  • Emergency lighting
  • Dimmable (analogue, DALI or DSI)
  • Multiwatt versions
  • HF motion sensor  >> more on sensor technology
  • CorridorFUNCTION  >> more info
  • Protection class II
  • Screwed cable gland M20
  • Diffuser PMMA clear
  • Alumimium reflector

Mounting method

Approved for indoor use or use in outdoor areas protected by a roof (see installation instructions).

  • Direct to ceiling or wall (vertical and horizontal)
  • With clip for ceiling installation
  • Pendant suspension
  • RTS trunking rail


Diffuser made of highly transparent, UV-stabilised polycarbonate (PC) with internal longitudinal prisms and etched surface structure. This diffuser is characterised by outstanding impact resistance and dimensional stability.

Diffuser made of UV-resistant polymethylmethacrylate (PMMA), with pearl structure. This diffuser boasts high translucency, surface hardness, resistance to weathering and ageing, and outstanding resistance to chemical influences.