Marks of conformity

CE
The CE-identification is performed by the manufacturer. The manufacturer, at the manufacturers own responsibility, hereby confirms conformity with the respective EC or EU directives. Conformity in accordance with the Low-voltage Directive and the EMV Directive (interference immunity, emitted interference) is the precondition for the CE-identification for our products.

VDE
Reiss standard luminaires are VDE-approved. They have the VDE-approval and are continuously tested in strictly stipulated quality controls. These controls are supervised by the VDE.

ENEC
The ENEC-Symbol is the European safety symbol for luminaires. The test regulations are determined by the European standard 60 598. The ENEC-Symbol is issued in combination with the identification number of a European test center (VDE = 10) This documents that the luminaires have been built and tested in 'conformity with the standards' as per the Low-voltage Directive 73/23 EEC.

F
All luminaires meet the F-conditions. In the event of faulty luminaire the fastening surfaces will not be hotter than 180°C. They may be mounted on inflammable building materials as described in DIN 4102 ignition point of at least 200°C (e.g. wood). Observe the installation instructions in order to avoid incorrect installation.

FF
VDE 0100 Part 720 requires that luminaires with the FF-symbol and at least with degree of protection IP 50 must be installed in areas where dust and/or fibres pose a fire hazard. Observe the installation instructions when installing.

M
Luminaires with the M-identification are intended for surface mounted installation in furniture. They have been designed so that inflammable materials as defined in DIN 4102 cannot be ignited in the event of a faulty luminaire. Observe the installation instructions in order to avoid incorrect installation.

D
New EN-test mark 'D' replaces the national FF-symbol.

IP 30
protected from solid debris larger than 2,5 mm but unprotected from moisture.

IP 40
protected from solid debris larger than 1,0 mm but unprotected from moisture.

IP 50
dustproof (ingression of dust not impossible) but unprotected from moisture.

IP 54
dustproof (ingression of dust not impossible) and protected from splash water (from all directions).

IP 65
dust-tight (no ingression of dust) and protected from jet water (from all directions).

IP 66
dust-tight (no ingression of dust) and protected from rough sea.

IP 67
dust-tight (no ingression of dust) and protected from immersion (with details about pressure and time).